Most boiler noises come from trapped air, limescale or heating sludge, or a loose part inside the casing. Many of these common sounds are not dangerous and can be sorted out with routine maintenance. However, kettling, a loud hissing noise or any smell of gas should not be ignored. Any fix inside the boiler needs a Gas Safe registered engineer.
Before you call a heating engineer, there are a few safe checks you can do without touching the inside of your boiler. First, turn the heating off and let the system cool down completely. This stops the noise and makes the radiators and pipework safe to touch if you need to check them. Never remove the boiler casing to look for the source of a noise. By law, only a Gas Safe registered engineer competent in that area of gas work may do gas work in a home.
Next, look at the pressure gauge on the front or underneath the boiler. Write the reading down so you can tell the engineer. A reading below 1 bar usually indicates low water pressure, but your boiler manual is the exact reference for where the needle should sit. If water is leaking near any electrics and it is safe to reach your consumer unit, switch off the electricity at the mains and catch the water in a bucket.
Banging and kettling
A loud banging noise from your boiler is most often traced back to a process called kettling. This happens when limescale builds up on the boiler heat exchanger, which is the part that transfers heat from the gas burner to the water. Limescale is much more likely to form if you live in a hard water area. The scale restricts the flow of water, causing it to overheat, turn to steam and expand rapidly. Central heating boilers normally run around 65 to 70 degrees Celsius, not 100 degrees.
Kettling should not be ignored because it reduces the efficiency of your heating, raises your energy use and can shorten the boiler's lifespan. Banging may also be the result of a build up of debris and heating sludge on the heat exchanger. Sludge is a mix of rust and dirt that gathers inside old radiators and pipes. If banging is hard or frequent, you need to get a heating engineer to inspect the system.
A faulty or wrongly set boiler thermostat can also cause a loud banging sound. Do not adjust the boiler thermostat yourself. If you suspect the thermostat, ask a Gas Safe registered engineer to test it.
If you hear banging away from the boiler, it is often water hammer in your pipes. Water hammer is a shockwave that happens when fast flowing water is stopped dead, usually when taps or showers are turned on or off suddenly. A plumber can look into the cause if it keeps happening.
Whistling
A high pitched whistling sound is more likely to be trapped air than kettling. An engineer can release the trapped air from inside the boiler casing, but they should also find out how that air is getting in.
Whistling can also point to a mechanical part struggling to move. One possible cause is a stuck or failing heating pump, which pushes hot water around your radiators.
In some cases, whistling is an early sign of kettling caused by limescale on the heat exchanger. The restricted flow can overheat the water and turn it to steam. Repairs generally need a Gas Safe registered engineer, so do not try to fix the cause yourself.
Gurgling and bubbling
Gurgling is caused by trapped air in the heating system, low water pressure or a frozen condensate pipe. A small amount of gurgling is fairly common as water moves through the pipes, but it should be investigated if it becomes loud or constant. You can tackle trapped air safely by bleeding your radiators. Use a radiator key to open the valve at the top of each radiator slightly until water appears, then close it tightly. You can read more about this in our guide on how to bleed a radiator.
If bleeding the radiators does not stop the gurgling, check your pressure gauge. A reading below 1 bar usually points to low pressure, which stops the water circulating properly. Your boiler manual explains what to do about low pressure.
Gurgling can also happen if the condensate pipe freezes outside in cold weather. The condensate pipe is a plastic tube that carries acidic waste water from the boiler to an outside drain. If this pipe freezes solid, the waste water backs up into the boiler and makes a bubbling noise before the boiler shuts itself down for safety. You can thaw an easily reached frozen condensate pipe by pouring warm, never boiling, water over it.
Any action you take yourself should only be a preliminary check. If you bleed the radiators, top up the pressure and thaw the pipe but the gurgling continues, a professional may need to drain the system completely to find the fault.
Humming, buzzing and vibrating
Vibrating is caused by loose brackets. You must call a Gas Safe registered heating engineer if the vibrating does not stop. You cannot remove the casing to tighten brackets yourself.
Trade guidance rates loud humming as low to moderate urgency, with a pump check advised. A Gas Safe registered engineer should check the pump, so do not adjust it yourself.
Trade guidance rates buzzing as low to moderate urgency and advises having a Gas Safe engineer inspect the electrical connections. Do not open the boiler to look yourself.
Trade guidance rates a deep rumbling noise as a moderate urgency issue. It can be a sign of sludge, which can damage the heat exchanger.
Hissing and when it is an emergency
Hissing is an emergency if the sound comes from gas pipework or the gas meter. If you suspect a water leak is near electrics, switch off the electricity at the mains and catch the escaping water in a bucket or bowl.
If you smell gas, or suspect a gas leak, you must act immediately. Call the National Grid Gas Emergency Freephone on 0800 111 999. Open all doors and windows to ventilate the property. Shut off the gas supply at the meter control valve if you know where it is. It is illegal to use a gas appliance you suspect is unsafe. Turn it off and leave it alone until a Gas Safe registered engineer has checked it. You can read the full official advice from the Health and Safety Executive on handling a gas emergency.
Carbon monoxide is a poisonous gas produced when gas appliances burn incorrectly. You cannot see, smell or taste it. The Health and Safety Executive states that carbon monoxide symptoms include headaches or dizziness, breathlessness, nausea, loss of consciousness, tiredness, pains in the chest or stomach, erratic behaviour and visual problems. If you or your family have these symptoms, get urgent medical advice from your GP or an Accident and Emergency department.
Never ignore a strong smell of gas or a sudden hissing sound. You can learn exactly what steps to take to keep your home safe in our guide on what to do if you smell gas.
Which noises are urgent
The table below shows the most common boiler noises, what they usually mean, the safe actions you can take and when to call a professional. Your own boiler manual is always the final word on what to do if a fault develops.
|
Noise |
What it often means |
Safe actions you can take |
When to call an engineer |
|---|---|---|---|
|
Banging or kettling |
Limescale on the heat exchanger, debris, or a faulty thermostat. |
Switch the heating off and let it cool. |
If the banging is hard or frequent, or you suspect the boiler thermostat. |
|
Whistling |
Trapped air in the system or a stuck and failing pump. |
Bleed your radiators using a radiator key to release trapped air. |
If bleeding the radiators does not stop the whistling noise. |
|
Gurgling |
Trapped air, low pressure or a frozen condensate pipe. |
Check the pressure gauge and thaw an easily reached external pipe with warm, never boiling, water. |
If the noise is loud and constant, or the pressure stays low. |
|
Vibrating |
Loose brackets holding the boiler or internal parts. |
Switch the heating off and note when the noise happens. |
If the vibrating does not stop. Do not open the casing. |
|
Hissing |
A possible gas leak from pipework or the meter. |
If you smell gas, open doors and windows and shut off the gas at the meter control valve if you know where it is. |
Immediately. Call 0800 111 999 if you smell gas. |
A noise on its own cannot confirm a fault, so an engineer should diagnose it.
What to tell the engineer
Give the heating engineer as much detail as possible when you call to book a repair. This helps them bring the right parts and tells them if the job is an emergency. Keep a note of these details ready by the phone.
- The exact type of noise, such as banging, whistling, gurgling, hissing or humming.
- When the noise happens, for example all the time, only when heating up, or when a tap is turned off.
- The current reading on your pressure gauge.
- Any fault code flashing on the digital boiler display.
- Whether you have already tried bleeding the radiators or thawing the condensate pipe.
- If you have any dripping water or if you have had to turn the mains water or electricity off.
How servicing helps prevent noises
Regular servicing can help avoid problems before they start. The Health and Safety Executive advises that gas appliances, flues and pipework should be regularly maintained and serviced at least annually. This should ideally be done by a registered engineer. Landlords must arrange an annual gas safety check by law and give their tenants the record.
Gas appliances, flues and pipework should be serviced at least annually, ideally by a Gas Safe registered engineer. Do not service the boiler yourself.
If your system is rumbling or banging because of heating sludge, a qualified professional should carry out a power flush to remove it. A power flush is a cleaning of the heating system. It is a job for a qualified professional and will not necessarily stop every noise. You can read about the process and what tradespeople charge in our power flush cost guide.
Limescale is more likely in hard water areas, so mention where you live when you describe the noise to the engineer.
Common questions
Is a dripping noise inside the boiler serious?
Heating guidance rates dripping as a moderate urgency because leaks can damage the circuit boards inside the boiler. Do not take the cover off to look for the drip. Place a bucket underneath if water is escaping from the casing and call a heating engineer to find the leak.
Why does my boiler click but not fire up?
Do not open the boiler to look for the cause of a click or a boiler that will not fire up. Note the pressure reading and any fault code, then ask a Gas Safe registered engineer to check it.
Can I tighten loose parts inside the boiler myself?
No. Do not remove the casing. Only a Gas Safe registered engineer competent in that area of gas work may do gas work in a home, so leave anything inside the boiler to them.
Will boiler cover pay to fix a noisy boiler?
Cover policies differ, so check your policy documents to see what is covered and what is excluded before you book an engineer.
Next steps
Many boiler noises are not dangerous, but you should not ignore them. Follow these steps to narrow down the problem safely.
- Turn off the heating and let the system cool down completely to stop the noise.
- Look at the pressure gauge on the front of the boiler and write down the reading.
- Bleed your radiators to release any trapped air causing gurgling or whistling.
- Check the outside condensate pipe for ice if the weather is freezing.
- Call the gas emergency number on 0800 111 999 immediately if you smell gas or suspect a leak.
Once you have checked the pressure and bled the radiators, note down exactly what the noise sounds like and when it happens. You can then find a plumber near you to get the system checked safely by a Gas Safe registered professional.
Find a top rated plumber near you
4,869 plumbers across the UK, each ranked on their Google rating and the number of reviews behind it. Start with your county: